Osstem Orthodontics Yes Metal SL Bracket (SLB) (Inter-Active)

• Isolation and Moisture Control: Ensure a dry operating field by using isolation techniques such as rubber dam or cotton rolls. Moisture can compromise the bonding process, so it’s crucial to maintain a dry environment.
• Clean Tooth Surface: Thoroughly clean the tooth surface where the bracket will be placed. Remove any debris or plaque using a fluoride-free pumice.
• Etching: Apply an orthophosphoric acid (etching gel) to the enamel surface. Etching creates a microstructure on the tooth enamel, enhancing the bond strength. Follow the recommended etching time specified by the adhesive manufacturer.
• Rinse and Dry: Rinse the tooth surface thoroughly to remove the etching gel, and then dry the tooth with oil-free, compressed air. Complete drying is essential for a successful bond.
• Apply Primer: Apply an orthodontic primer to the etched tooth surface. The primer promotes adhesion between the enamel and the bonding adhesive.
• Light Cure Primer: Some primers may require light curing. Use a curing light to polymerize and set the primer on the tooth surface. Follow the recommended curing time.
• Apply Adhesive: Apply the orthodontic adhesive to the back of the bracket. Position the bracket accurately on the tooth, ensuring proper alignment.
• Light Cure Adhesive: Cure the adhesive using a curing light. This step bonds the bracket to the tooth surface. Follow the recommended curing time for the adhesive.
• Attach Archwire: Once the brackets are securely bonded, thread the orthodontic archwire through the brackets. This wire exerts pressure on the brackets to gradually move the teeth.
• Secure with Ligatures: Use ligatures or other mechanisms to secure the archwire in place within the brackets.
• Adjustments: Periodically adjust the archwire and make any necessary changes to the brackets based on the treatment plan. This may involve changing wires or adding elastics.
• Monitoring and Follow-up: Regularly monitor the patient’s progress and make adjustments as needed during follow-up appointments.

Osstem Orthodontics Yes (Inter-Active) Metal SL Brackets Opener

How to open the cap (Maxillary)

• Place the lower head part of the opener on the opening slot and gently pull it down in the occlusal direction.
• Fully opened condition.(General opening process In case of rough opening. place the upper head part of the opener to the edge of the clip and push it down softly and then follow (Rough Opening process).

How to open the cap (Mandibular)

• Place the lower head part of the opener on the opening clip slot and gently pull it up in the occlusal direction.
• Fully opened condition. (General opening process In case of rough opening, place the upper head part of opener to the edge Of clip and pull it up softly, (Rough Opening process).