Scheu Biocryl “C” 125 mm 10/pk

MODEL PREPARATION-

• Larger areas, as for example the sublingual area, should be protected with blocking out putty (REF 3220). Smaller
  undercuts can be blocked out using SIL-KITT (REF red 3442 / REF 3443 transparent). ISOFOLAN® foil (REF 3207) is
  recommended for isolation, providing at the same time optimum transparency and an aesthetically smooth inner
  side of the splint that can be easily cleaned. Depending on the application, clasps and screws – if required –
  are fixed on the vestibular side with sticky wax. In case of preparing immediate dentures, the silicone matrix with
  the prepared teeth must be fixed, too.

PRESSURE MOULDING –

• Embed the vestibular model parts up to the occlusal surfaces into the pellets. Mix BIOCRYL®-RESIN and apply it to
  the retentions or under the teeth in the last 20 – 30 seconds of the heating time. For complete polymerization, the
  cooling phase should be at least 300 seconds.

FINISHING-

• The cutting bur (REF 3214) is best suited for initial finishing. The clasps and the labial arch can be exposed using
  the finishing bur (REF 3377), made of a special soft alloy that will not damage the wire elements. The saw cut for the
  expansion screw is done with the set-up manual saw (REF 5372) or the diamond separating disc (REF 5288).
  For trimming and smoothing we recommend using DIMO® brown (REF 3382) and DIMO® green (REF 3383).