Features
- Dual Core versatility
- Reduced post-operative sensitivity
- High bond strength to both dentine and enamel
Description
It is a two component system to be used with self-curing and dual curing resin cements to bond all indirect restorations including metal, ceramic and composite crowns, inlays, onlays, veneers and bridges retainers and bonding of Endodontics posts.
INDICATIONS:
- Direct , light cured/self-cure composite restorations and core build-up.
- indirect restoration resin cemented inlays, Onlays, crowns and bridge retainers.
- Direct, light cured/self-cured composite and compomer restorations.
- Endodontic post cementation.
- Bonding of indirect restorations and light/self-cure resin cemented veneers.
Composition :
Fusion Bond DC Bonding Agent contains Urethane Dimethacrylate, Triethylene Glycol Dimethacrylate, Bisphenol A Diglycidyl Methacrylate, Tertiary Butanol, Photoinitiators, Stabilizer,
Ethoxylated Bisphenol ADimethacrylate.
Fusion Bond DC Activator contains Urethane Dimethacrylate, Triethylene Glycol Dimethacrylate, Bisphenol ADiglycidyl Methacrylate, Tertiary Butanol, Curing Agent, Stabilizer.
Packaging
- 1 x 5ml Bonding Agent
- 1 x 5ml Activator
- 20 x Micro Brushes
Direction to Use
Direct Restoration :
1. Clean the prepared root canal or cavity with water spray and then air dry.
2. In deep cavities / preparations, cover the dentine close to the pulp with hard setting calcium hydroxide liner (Cal LC ) or glass ionomer liner (I-Seal).
3. Apply Etching Gel (Actino Gel) to the Cavity surfaces starting at the enamel margins. Condition for 15 Seconds.
4. Rinse with vigorous water spray and dry the cavity surfaces completely by blowing gently with an air syringe. Do not desiccate dentine. Proceed immediately to apply Fusion Bond DC.
Mixing Directions : Dispense 1-2 drops of Fusion DC Bond Agent and equal numbers of Fusion Bond DC Activator into a clean dappen dish or mixing well. Replace cap promptly. Mix both the components for 3-4 sec. Apply using a disposable brush. Wet all the tooth surfaces uniformly. Gently evaporate solvent by thoroughly drying with clean, dry air for at least 5 sec. If required repeat application and air dry and light cures if desired. Cure for 20- 30 sec using a curing light.
