Cerkamed Rubber – dam Liquid Mega Pack

Features

• New quality of work
• Perfect protection of soft tissues
• Wide range of use

Description

Suitable for occlusal stamp technique

Composition

• Urethane resins
• Inorganic fillers

Indications

• Gingiva protection during dental treatments: whitening, etching, microabrasion, sandblasting etc
• Used for sealing rubberdam

Key Specifications

Composition

• Urethane resins
  
• Inorganic fillers
  

Packaging

• 4 ? 1.2mlSyringes
• Disposable applicators

Direction of use

For gingiva protection during dental treatments:

• Step 1

Clean and dry gingiva. With the use of appropriate instruments (e.g. buccal and labial retractor) immobilize lips and a tongue in order to avoid contact with the liquid.

• Step 2

Remove the syringe lock and install the included disposable applicator.

• Step 3

Apply RUBBER-DAM LIQUID along the application area 4-6 mm wide and approximately 1.5-2 mm thick, at the same time overseeing the amount of the preparation being applied.

• Step 4

If possible, squeeze RUBBER-DAM LIQUID through interdental space.

• Step 5

Cure the preparation for 20-30 seconds using polymerization lamp. Conduct the curing process evenly in a scanning motion. Then, proceed the dental treatment.

• Step 6

After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on the either side and remove.

In order to seal rubber dam:

• Step 1

Isolate the working area (tooth, teeth, alveolus) using RUBBER-DAM.

• Step 2

In order to seal rubber dam, apply the layer of the liquid on the edge of the gingiva and the rubber dam.

• Step 3

Cure the preparation for 20-30 seconds using a light cure unit . Conduct the curing process evenly in a scanning motion. Then, proceed the dental treatment.

• Step 4

After the treatment is completed, lift off polymerized RUBBER-DAM LIQUID using the instrument on either side and remove.

• Step 5

Immediately after the use withdraw the syringe plunger and place the original cap on the container to avoid polymerization of the product in the syringe.

• Step 6

The product is intended for reusing, while the applicator is designed for disposable use. Reusing the applicator may cause the hazard of re-infection.